Defer putting drip edge on angled gable ends until after the felt is laid so the metal.
Rolled roof felt nailing pattern.
However there are other advantages to roll roofing including that it can last up to 12 years.
Anchor the top corner of the felt after it has been properly positioned and roll the felt out across the roof.
Installing the roofing felt does take care but can go very quickly.
Nail down the 18 inch roll roofing sheet that it is covering the valley.
Roll roofing is by far the easiest type of roofing to install.
The roofing should overhang the eaves by inch except where you install drip edge flashing on top of the roofing along the rake edge.
Roll out the felt toward the other end of the roof.
The top edge of the felt should be nailed no less than every eight inches.
Contact roofhelp 12 24 nailing pattern for roofing felt each row of nails that are 24 on center should be approximately 12 from the outside edge of the roll.
These applications are ideal for flat roofs or protective surfaces under roof level decks.
Tear out the sheathing that is emerging out of the valley.
Some roofing felts are actually glued down.
This video walks through the very basic steps for installing tarpaper felt.
Setting the roll and then nailing off.
You will need 1 10 gallon of lap not mastic cement for every roll and 2 pounds of roofing nails for every square.
The nails should start 3.
Fasten drip edge on eaves with galvanized nails and a hammer about 12 inches apart before laying roof felt.
This is why so many people choose roll roofing over other types of roofing material.
Be sure that there are no wrinkles.
Starting a roof with tarpaper felt.
Cover the preceding layer with 36 inch roll roofing.
Pay careful attention to roll the felt out smoothly avoiding wrinkles as you move across the roof.
Pick up the roll with both hands.
These thick layers of roofing felt are installed by heating the back of the felt with a butane torch and then carefully applying it to the roof.
Hammer down the nails at the edges of the sheets covering the valley.
Contact roofhelp 9 18 nailing pattern for roofing felt each row of nails that are 18 on center should be approximately 12 from the outside edge of the roll.
Move over to the other spaces of the roof and start installing the roofing courses one by one in a definite pattern.
From behind the roll reach over and nail down the top of the strip with roofing nails spaced 6 to 8 inches apart.
